After the power carving was finished, we changed grinder that is angle to a flap disk sander wheel.

After the power carving was finished, we changed grinder that is angle to a flap disk sander wheel.

they are low priced small discs which you can use to smooth out of the rough surface that the energy carving put aside.

The very last little bit of sanding is completed by hand and therefore simply involves some elbow oil plus some modern grit sandpaper. We began with 80 grit and cleaned up the flaws kept by the angle grinder. I quickly relocated up through the grits last but not least stopped as soon as we reached 220.

Action: Cutting to Final Dimensions

With every thing sanded, we are able to now trim the banner to it is last proportions. The height and thickness associated with the flag is undoubtedly currently at its last proportions so we only have to concern ourselves utilizing the width. First start with with your tablesaw to trim down an extremely edge that is fine among the edges to flush things up.

Next, mark the last width at 2′ 7 1/4″ and cut one other part. By initially cutting each stripe board at 2′ 7 1/2″ inches, this gave you 1/4″ inches of “slop” so that you should manage to flush up both edges. In case things had been a lot more than 1/4″ away from square during glue up, do not sweat it. Simply cut the edges flush because nobody will notice in the event that you’re down inch that is 1/8th therefore. But be warned. if we come up to go to, i am bringing my tape measure. 🙂

Step : Taping the Stripes

that is perhaps one of the most frustrating parts associated with the task therefore be warned! Into the video clip We explain why We made a decision to get the path of employing painter’s tape accompanied by HVAC foil tape. Then by all means go for it if you can think of a simpler easier method! Begin by using painter’s tape to tape down all the “white” stripes (there are 6 of those) plus the union (approx 12 3/8″ wide by 7 stripes high). Continue reading “After the power carving was finished, we changed grinder that is angle to a flap disk sander wheel.”